DIY Stainless Steel Host Assembly, Extended and Tapered Heat Sink, Unmarked

This is an unmarked, brushed finish stainless steel host assembly that includes the body (retaining ring, heat sink holder, battery holder and tail cap with "clicky" switch and wrist strap), your choice of driver pill, brass ring, a new extended and tapered copper heat sink with set screw and a 0.050" Allen wrench. The heat sink is machined to fit a standard 12mm diameter diode module. Does not come with diode, driver circuit or other components. Can be used with P/N SL-DDM1.4 or SL-DDMV diode & driver modules or flashlight parts bundles, or in your own custom build. We recommend that the driver wires be approximately 1.25" long for the diode module to fit properly. Will not work with the SL-DDM1 diode and driver module because the driver wires are too short. Designed for use with two rechargeable RCR123A or disposable CR123A batteries, or a single 18650 battery depending on diode and driver used.

Overall Length: 4.94"
Maximum Diameter: 0.96"
Weight: 191 grams