DANGER: APPROPRIATE LASER SAFETY GOGGLES MUST BE WORN WHEN OPERATING THIS DIODE! RISK OF INSTANTANEOUS SEVERE EYE DAMAGE OR BLINDNESS! A 5.6mm diameter 445nm M140 diode pressed into a solid copper diode module with wire extensions attached. These diodes have been tested and sorted and will produce 2,200mW +/-100 mW at 1.8A current with a G-1 or G-2 lens. Diodes are fully installed into the module using a diode press for maximum heat transfer during operation. Wire lead extensions are approximately 1" long 26 AWG silicone insulated for flexibility and durability, solder joints are protected with heat shrink tubing. Packaged in an aluminized Mylar conductive plastic bag.
Note: Use of an extended or extended and tapered copper heat sink is highly recommended with this diode.
How to solder a diode to a driver
Notice: Due to the sensitive nature of electronic components, the "DIY" parts and assemblies are sold "as is" and without warranty. Do not purchase the "DIY" products if you are unskilled in soldering and ESD techniques.
Updating Order Details
Please do not refresh or navigate away from the page!